How to make Banana Beer:

How to make Banana Beer
By pinoyfarmer | August 6, 2007

Banana beer is made from bananas, mixed with a cereal flour (often sorghum flour) and
fermented to an orange, alcoholic beverage. It is sweet and slightly hazy with a shelf life of
several days under correct storage conditions. There are many variations in how the beer is made. For instance, Urwaga banana beer in Kenya is made from bananas and sorghum or millet and Lubisi is made from bananas and sorghum.

Raw material preparation

Ripe bananas (Musa spp.) are selected. In the rainy season unripe bananas can be left to
finish ripening laid on a hurdle over the fire where the cooking is done. During the dry season bananas can be ripened by making a pit in the ground, covering the sides of the pit with green banana leaves, packing the bananas in to the pit and then covering them with banana leaves and earth. On one side of the pit a little ditch should be dug for a fire so that warmth and smoke can enter the pit. This takes about six days. The bananas should then be peeled. If the peels cannot be removed by hand then the bananas are not sufficiently ripe.

Processing

The first step is the preparation of the banana juice. The extraction of a high yield of banana juice without excessive browning or contamination by spoilage micro-organisms and proper filtration to produce a clear product is of great importance. Grass can be used to squeeze the banana so that only a clear juice is obtained. The residue will remain in the grass.

One volume of water should be added to every three volumes of banana juice. This makes the total soluble solids low enough for the yeast to act. Cereals are ground and roasted and added to improve the colour and flavour of the final product. The mixture is placed in a container, which is covered in polythene to ferment for 18 to 24 hours. The raw materials are not sterilised by boiling and therefore provide an excellent substrate for microbial growth. It is essential that proper hygienic procedures are followed and that all equipment is thoroughly sterilised to prevent contaminating bacteria from competing with the yeast and producing acid instead of alcohol. This can be done by cleaning with boiling water or with chlorine solution. Care is necessary to wash the equipment free of residual chlorine, as this would interfere with the actions of the yeast. Strict personal hygiene is also essential. For many traditional fermented products, the microorganisms responsible for the fermentation are unknown to scientists. However, there has been research to identify the micro-organisms involved in banana beer production. The main micro-organism is
Saccharomyces cerevisiae which is the same organism that is involved in the production of grape wine. However, many other micro-organisms were identified. These varied according to the region of production. After fermentation the product is filtered through cotton cloth.

Flow diagram

Raw materials
Ripe bananas
Peel
Peel by hand
Remove residue
Use grass to knead or squeeze out the juice
Mix with water
The water: banana juice ratio should be 1:3
Mix with cereals
Mix with ground and roasted cereals to local taste
Ferment
In plastic container. Leave to ferment for 18 to 24 hours.
Filter
Through cotton cloth
Pack
Store
Packaging and storage

Packaging is usually only required to keep the product for its relatively short shelf life. Clean glass or plastic bottles should be used. The product should be kept in a cool place away from direct sunlight.